LED ADR-kentekenplaathouder incl. verlichting 1,5 m + 1,5 mm²-connector
€ 128,55
Prijs incl. btw · € 106,24 prijs excl. btw
19 op voorraad
Bestel vóór 16:00 — verzending volgende werkdag
+ verzending vanaf € 7,50 · gratis vanaf € 350,00
Specificaties
General
- Voltage
- 12-24v
- IP rating
- IP69K
- Certifications
- ADR, CE, ECE-R10, ECE-R4
- Warranty
- 2 jaar
Dimensions
- Dimensions
- 552 x 143 x 36mm
- Width
- 552mm
- Depth
- 36mm
- Height
- 143mm
Materials
- Housing colour
- Black
- Housing material
- Polycarbonate
- Lens material
- Polycarbonate
Technical
- Connector
- 1.5mm² connector
- Cable length
- 150cm kabel
Lees u verder in
More guidesVehicle type
Semi-trailer lighting — markers, rears, end-outline.
A semi-trailer takes more lamps than the tractor pulling it: side markers every 3 metres, end-outline markers at the corners, twin rear combinations, licence-plate lamps, and on tank or curtain-side variants additional under-running protective lamps. This page covers the spec, the failure modes, and what to fit on which trailer type.
Read article
Vehicle type
Trailer lighting — small trailers and tow-behinds.
Single-axle and tandem-axle trailers towed by passenger cars or vans run on the simplest electrical systems on the road: 12V, no CAN-bus, and a 7-pin or 13-pin connector to the towing vehicle. The lighting decisions are also the simplest — but get them wrong and the trailer fails its annual inspection.
Read article